B2005Plus Wet & Dry
High-end Robot Vacuum Cleaner B2005Plus
Get to know the cleaning effect of B2005Plus
Wet & Dry Mopping
The mop can not only mop the floor, but also drip the water
automatically and evenly.
The charm of B2005Plus
Wet & Dry Mopping
The mop can not only mop the floor, but also drip the water automatically
B2005Plus has various cleaning modes, including auto cleaning mode, spot cleaning mode, edge cleaning mode, scheduling mode.
Smart Technology of frequency conversion
The application of frequency conversion to Robot Vacuum Cleaner B2005Plus and the electric eye installed inside the dust absorption
area, makes the robot recognize the dust while it does the cleaning
and focus on cleaning the area with much dust, avoiding the robot
Various Cleaning Modes
Robot vacuum cleaner that can do mopping and
vacuuming better than human power.
To explore new territory
The cleaning effect
Double side brushes make B2005Plus clean the corners perfectly. Central hole structure avoids the suction inlet being blocked by
Mop of 370 square centimeters does the mopping as human do.
Double Side Brushes
The robot will go back to the charging base to recharge at low
With 90mm in height
With 90mm in height, the robot can go through the furniture like
sofa, table and bed easily.
Smart Recharging Design
With the intelligent infrared introduction of anti-falling, the robot
will automatically recognize the edge and avoid falling down from
stairs or tables.
B2005Plus will turn around when it runs to the furniture then
effectively avoids the damage caused by the collision.
The UV light will kill the bacteria on the floor and carpet, keeping the house clean and healthy.
The virtual blocker makes the robot work within certain area where
you want it to be cleaned.
The dust and rubbish is separated so that the suction port will not
be blocked. The primary filter and HEPA filter can filter micro dust
and prevent secondary pollution.
50DB noise will not disturb you when you are at work and at rest.
Filters prevent secondary pollution
Daily maintenance so easy
Clean the Roller Brush
A.Check side brushes for damage or foreign object on the brush.
B.Clean the side brushes
C.Remove the screws of the side brushes, Replace brushes with new ones, Use screws to lock the new brushes in place.
Clean Sensors and Charging Poles
Clean the sensors and charging poles per week or according to daily use to make sure the robot is well maintained.
Wipe the sensor window and auto charging sensors with a soft dry cloth.
Clean charging contacts on self charging base
Clean vacuum intake and dust sensors as shown in the pictures.
Note: After taking out dustbin, check if there is foreign object stuck or block the vacuum passage and clean it if necessary.
A.Press "PUSH" to open the dustbin cover.
B.Take out the dustbin
C.Separate HEPA filter from dustbin.
D.Pull out dustbin top cover and take out primary filter.
E.Empty dustbin and wipe the dust.
F. Wash dustbin with water.
Clean and Replace Filters
Clean filters with cleaning brush tool.
Note: Clean dustbin module when the trash icon flashes on the display
Install primary filter and HEPA filter into dustbin.
Note: 1. Install both HEPA and primary filters when they are dry.
2. Do not place HEPA and primary filters directly in the sun.
Close dustbin cover and install it into main unit.
Note: Dustbin and Filters( including HEPA and filter) could be replaced if needed.
How to handle the water tank trailing bar
1.Open the water injection hole, after water injected, stick the mop to the right place.
2.Aim at the relevant holes and assemble the trailing bar on the cleaner.
Choose one robot best for you
Cleaning with central brush
Intelligent Dust Detection
2000 mAH Ni-MH
About 90 mins